Metro L3-061 1.0L VIN 6 TBI (1998)
5. Two TORX(R) head screws and inflator module from steering wheel.
WARNING: When carrying a live inflator module, make sure the bag and trim cover are pointed away from you. In case of an
accidental deployment, the bag will then deploy with minimal chance of injury. Never carry the inflator module by the wires or connector
on the underside of the module. When placing a live inflator module on a bench or other surface, always face the bag and trim cover up,
away from the surface. Never rest a steering column assembly on the steering wheel with the inflator module face down and column
vertical. This is necessary so that a free space is provided to allow the air bag to expand in the unlikely event of accidental deployment.
Otherwise, personal injury could result.
INSTALL OR CONNECT
1. Inflator module to steering wheel.
2. Two TORX(R) head screws; securing inflator module to steering wheel.
^
Tighten inflator module-to-steering wheel screws to 23 Nm (17 ft. lbs.).
3. Two horn wire connectors and right side steering wheel trim cover.
4. Negative (-) battery cable.
5. Enable the SIR.
