Monte Carlo V6-3.8L SC VIN 1 (2004)
4. Use a small, flat-bladed tool to remove the push-in retainer from the front of the front seat cushion trim panel.
5. Pull off the front seat cushion trim panel to release the two retaining clips located on each side the recliner handle hole.
6. Remove the power seat switch from the front seat cushion trim panel, if equipped.
7. Remove the heated seat switch from the front seat cushion trim panel, if equipped.
8. Remove the lumbar control switch from the front seat cushion trim panel, if equipped.
9. Remove the front seat cushion trim panel from the vehicle.
INSTALLATION PROCEDURE
1. Install the power seat switch to the front seat cushion trim panel, if equipped.
2. Install the lumbar control switch to the front seat cushion trim panel, if equipped.
3. Install the heated seat switch to the front seat cushion trim panel, if equipped.
4. Install the seat cushion trim panel, pressing in until the two retaining clips are fully seated.