Monte Carlo V6-3.8L SC VIN 1 (2004)
1. Install the spindle rod (5) to the vehicle.
2. Install the spindle rod (5) to the knuckle (8).
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the spindle rod to knuckle bolt (4) and nut.
^
Tighten the nut to 150 Nm (110 ft. lbs.).
4. Install the spindle rod to the rear suspension support.
5. Install the bolt (1) and nut to the rear suspension support.
^
Tighten the bolt to 140 Nm (103 ft. lbs.).
6. Install the rear suspension support.
7. Install the tire and wheel assembly.
8. Lower the vehicle.
9. Adjust the wheel toe angle.
