Prizm L4-108 1.8L DOHC VIN 8 MFI (1998)
Air Bag Control Module: Service and Repair
Installation Procedure
1. Install the SDM assembly (1) into the vehicle, taking care to ensure that the connectors are pointing toward the rear of the vehicle.
2. Install the three SDM fasteners (2).
Notice: Refer to Fastener Notice in Cautions and Notices. See: Restraint Systems/Air Bag Systems/Air Bag/Service Precautions
Tighten
Tighten the fasteners to 20 N.m (14 lb in).
3. Install the SDM electrical connectors.
4. Install the under seat duct.
5. Install the PCM. Refer to PCM Replacement.
6. Install the center console and then install the rear console.
7. Enable the SIR system. Refer to Enabling the SIR System. See: Body and Frame/Interior Moulding / Trim/Dash Board / Instrument Panel/Air
Bag(s) Arming and Disarming/Service and Repair/Air Bag Disarming and Arming/Enabling the SIR System
