Prizm L4-108 1.8L DOHC VIN 8 MFI (1998)
9. If the vehicle is not equipped with a front stabilizer shaft, install the two bolts (1, 9). Do not tighten the bolts.
10. If the vehicle is not equipped with a front stabilizer shaft, install the two studs (3, 7).
Tighten
Tighten the two studs to 147 Nm (109 ft. lbs.).
11. If the vehicle is not equipped with a front stabilizer shaft, install the two nuts (2, 8)
Tighten
Tighten the two nuts to 19 Nm (14 ft. lbs.).
12. Install the following to the right control arm:
^
The two nuts
^
The one bolt
Tighten
Tighten the nuts and the bolt to 142 Nm (105 ft. lbs.).
13. Install the following to the left control arm:
^
The two nuts
^
The one bolt
Tighten
Tighten the nuts and the bolt to 142 Nm (105 ft. lbs.).
14. Remove the jack from the center of the crossmember.
