S10/T10 Blazer 2WD V6-4.3L VIN X (2003)
8. Install the new nut to the relay rod ball stud at the pitman arm.
Tighten the relay rod ball stud nut at the pitman arm to 48 Nm (36 ft. lbs.).
9. Install the inner tie rod ball studs to the relay rod. Ensure that the seal is on the stud.
10. Seat the taper using J 29193 or J 29194.
Tighten J 29193 or J 29194 to 54 Nm (40 ft. lbs.).
11. Remove J 29193 or J 29194 from relay rod ball stud. Repeat steps 10 and 11 for opposite inner tie rod to relay rod.
12. Install the new nuts to the inner tie rod ball studs.
Tighten the inner tie rod ball studs nuts to 47 Nm (35 ft. lbs.).
13. Lower the vehicle.
14. Adjust the front toe.
