S10/T10 Blazer 4WD V6-4.3L VIN W (1997)
Axle Shaft Assembly: Service Precautions
NOTICE: Always use the correct fastener in the proper location. When you replace a fastener, use ONLY the exact part number for that application.
The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the fasteners that require
thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or other corrosion inhibitors)
on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and the joint clamping force, and may
damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these instructions can help you avoid
damage to parts and systems.
NOTICE: Handle drive axles with care when they are removed from the vehicle. Allowing the inboard joint to over-extend can cause separation of
internal components and joint failure.
