S10/T10 Blazer 4WD V6-4.3L VIN W (1997)
2. Drive axle nut.
^
Insert a drift or large screwdriver through brake caliper into rotor vanes to prevent from turning.
3. Washer.
4. Brake Caliper.
Important: Support the caliper with a piece of wire to prevent damage to the brake hose.
5. Hub and bearing assembly from axle joint splined shaft using J28733-B.
6. Rotor. Refer to "Rotor Replacement."
7. Bolts.
Important: Lay the hub and bearing assembly on the hub bolt (outboard) side. This will prevent damage or contamination of the bearing seal.
8. Splash shield.
9. Cotter pin.
10. Nut.