S10/T10 P/U 2WD L4-2.2L VIN 4 (1995)
INSTALL OR CONNECT
CAUTION: Thoroughly coat the bottom of the Ignition control module with P/N 1974984 silicone dielectric grease. Failure to do so could result
in premature failure of the module.
^
Lubricate the bottom of the ignition control module and the module rest pad in the housing with P/N 1974984 silicone dielectric grease or an
equivalent heat transfer substance.
1. ignition control module to the housing with two screws.
2. Pole piece.
3. Pickup coil.
^
Fit the tab on the bottom of the coil into the anchor hole in the housing.
4. Pickup coil wiring connector to the module.
^
Make sure the locking tab is in place.
5. Shield onto the coil.
6. Retainer.
7. Lubricate the lower housing bushing with a few drops of engine oil.
8. Shaft assembly into the housing.
9. Tang washer, washer, and driven gear onto the bottom of the shaft.
^
Align the marks on the driven gear, housing. and shaft assembly.
10. Roll pin into the gear.
^
Spin the shaft and make sure the teeth on the shaft assembly do not touch the pole piece.
11. Rotor onto the shaft.
^
Fit the tab in the rotor into the shot on the shaft.
12.
Cap to the housing with screws and washers.