Silverado 2500 2WD V8-8.1L VIN G (2005)
3. Remove the following components from the seat cushion frame:
-
The frame springs (1)
-
The frame suspension (2)
-
The plastic retainers (3)
4. Remove the seat cushion frame from the vehicle.
INSTALLATION PROCEDURE
1. Install the following components to the seat cushion frame:
-
The plastic retainers (3)
-
The frame suspension (2)
-
The frame springs (1)
2. Install the seat cushion trim cover and pad.
3. Install the seat trim panel.
4. Re-zero the inflatable restraint passenger presence system. Refer to Passenger Presence System Programming and Setup in Restraint Systems.
Seat Cushion Cover and Pad Replacement - Rear
SEAT CUSHION COVER AND PAD REPLACEMENT - REAR
REMOVAL PROCEDURE
1. Remove the rear seat from the vehicle.
2. Remove the rear passenger seat riser.
3. Remove the hog rings and/or the J-clips from the rear edge of the seat cushion cover (3).
4. Disconnect the rear heater connector, if equipped.
5. Remove the seat belt buckles, if required.
6. Remove all of the remaining hog rings, and/or the J-clips that are retaining the seat cushion cover (3) to the seat cushion frame (8).
7. Release the hook, and the loop-strips that are retaining the seat cushion cover to the foam pad (4).
8. Remove the center screw retaining the latch cover, if equipped.
9. Remove the seat cushion cover from the foam pad.
