Silverado 2500 2WD V8-8.1L VIN G (2005)
1. Install the anti-rattle clips to the caliper bracket.
2. Install the brake pads.
3. Install the caliper to the caliper bracket.
4. Perform the following procedure before installing the caliper bracket bolts and the caliper bolts:
1. Remove all traces of the original adhesive patch.
2. Clean the threads of the bolt with brake parts cleaner or the equivalent and allow to dry.
3. Apply Threadlocker GM P/N 12345493 (Canadian P/N 10953488) to the threads of the bolt.
5. Install the brake caliper bolts. DO NOT tighten.
6. Install the caliper and caliper bracket as an assembly.
7. Notice: Refer to Fastener Notice in Service Precautions.
Install the brake caliper bracket bolts.
Tighten the bolts to 300 Nm (221 ft. lbs.).
8. Tighten the brake caliper bolts.
Tighten the bolts to 108 Nm (80 ft. lbs.).
9. Remove the rubber cap or plug from the exposed brake hose fitting end.
