Silverado 2500 2WD V8-8.1L VIN G (2005)
19. Position the engine harness over the engine compartment.
20. Connect the following electrical connectors:
^
Generator (2)
^
Injector harness (3)
^
Ignition coil harness (4)
^
ETC (5)
^
Purge valve solenoid (1)
21. Install the CPA retainer at the ignition coil harness.
22. Install the engine harness bolt and studs
^
Tighten the bolt to 16 Nm (12 ft. lbs.).
^
Tighten the studs to 10 Nm (89 inch lbs.).
23. Connect the following electrical connectors:
^
MAP sensor (1)
^
Ignition coil harness (2)
^
ECT sensor (3)
24. Install the CPA retainer at the ignition coil harness.
25. Position engine harness branch over the top of engine.
26. Connect the following electrical connectors:
^
Pressure cycling switch (1)
^
Surge tank switch (2)
^
MAF sensor (3)
