Silverado 2500 4WD V8-6.6L DSL Turbo (2010)
4. Position the transmission fluid fill tube.
5. Install the transmission fluid fill tube to bellhousing nuts.
Tighten the nuts to 18 Nm (13 lb ft).
Note: Prior to tightening the turbocharger exhaust clamp, ensure that the turbocharger exhaust pipe is inserted into the clamp.
6. Tighten the turbocharger exhaust pipe to turbocharger clamp bolt (1).
Tighten the bolt to 15 Nm (11 lb ft).
7. Install the catalytic converter. Refer to Catalytic Converter Replacement (LY6 with Exhaust Flange) (See: Catalytic Converter/Service and
Repair)Catalytic Converter Replacement (L9H with Exhaust Flange) (See: Catalytic Converter/Service and Repair)Catalytic Converter
Replacement (Gen IV Engines with Exhaust Clamp) (See: Catalytic Converter/Service and Repair)Catalytic Converter Replacement (LFA with
Exhaust Clamp) (See: Catalytic Converter/Service and Repair)Catalytic Converter Replacement (LMM) (See: Catalytic Converter/Service and
Repair).
8. Tighten the turbocharger exhaust pipe to bracket bolt.
Tighten the bolt to 34 Nm (25 lb ft).
