chevrolet Workshop Repair Guides

Chevrolet Workshop Service and Repair Manuals

ABOUT US
A/C - HVAC Control Module Lockup During Reprogramming|Page 11145 > < A/C - HVAC Control Module Lockup During Reprogramming|Page 11143

Silverado Classic 3500 4WD V8-6.6L DSL Turbo (2007)

Page 4
background image

3. Install the air inlet tube and NEW gaskets.

Notice:  Refer to Fastener Notice in Service Precautions.

4. Install the air inlet tube nuts.

Tighten the nuts to 25 Nm (18 ft. lbs.).

5. Connect the intake air heater electrical connector.
6. Connect the MAP sensor electrical connector.
7. Install the engine harness clip to the air inlet tube.

8. Install the air inlet tube to intake manifold tube bolt and nut.

Tighten the bolt/nut to 10 Nm (89 inch lbs.).

A/C - HVAC Control Module Lockup During Reprogramming|Page 11145 > < A/C - HVAC Control Module Lockup During Reprogramming|Page 11143