Sprint L3-61 1.0L (1988)
3. Remove two attaching nuts and washers.
4. Remove master cylinder.
Master Cylinder Piston To Booster Piston Rod Clearance
5. Adjust clearance of booster piston rod to master cylinder piston as follows:
NOTES:
-
Before measuring clearance, push piston rod several times so as to make sure reaction disc is in place.
-
Take measurement with gasket installed to master cylinder.
-
Keep inside of booster at atmospheric pressure for measurement.
Fig. 4 Tool J-34873 installation
a. Set measuring tool J-34873 on master cylinder and push pin until it contacts piston.
