Suburban 3/4 Ton 4WD V8-6.0L VIN U (2004)
1. Position the seat cushion in the forward position.
2. Release the seat cushion trim cover J channel along the lower edge of the trim cover.
3. Disconnect electrical connections from the ventilation heat and cool blower.
4. Note the location of the tie straps securing the ventilation heat and cool blower bracket to the seat cushion.
5. Remove the tie straps (3) retaining the ventilation heat and cool blower and bracket assembly to the seat cushion.
6. Remove the clip (1) securing the duct to the seat cushion frame.
7. Remove the ventilation heat and cool blower and bracket (2) from the seat cushion frame.
8. Drill the rivets (1) securing ventilation heat and cool blower (3) to the bracket (2).
CAUTION: Eye protection must be worn when drilling rivets to reduce the chance of personal injury.
INSTALLATION PROCEDURE
