Tracker 2WD L4-1.6L VIN 6 (2000)
8.3. Remove the fresh/recirc control cable from the blower case.
8.4. Remove the 1 screw and the blower relay bracket from the blower case.
8.5. Remove the wiring harness retainers from the blower case.
8.6. Remove the PCM.
8.7. Remove the 4 nuts (1).
8.8. Remove the blower case from the vehicle.
9. Remove the nut from the center of the bulkhead on the engine side (1).
10. Remove the 2 nuts from the heater case (2).
11. Separate the floor ducts from the heater case.
12. Remove the heater case from the vehicle.
Disassembly Procedure
1. Remove the 8 heater case retaining clips.
2. Remove the screw and the blend door linkages.
3. Separate the heater case halves.
4. Remove and replace the following components as necessary:
-
The defrost switch (1)
-
The blend doors (3)
-
The heater core (2)
-
The linkages
Assembly Procedure
