Tracker 2WD L4-1.6L VIN 6 (2000)
1. Install the new valve rocker arm cover gasket (1) and four O-rings (3) to the valve rocker arm cover (2).
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the valve rocker arm cover to the cylinder head. Secure the cover with six bolts.
^
Tighten the valve rocker arm cover bolts to 10 Nm (89 inch lbs.).
3. Install the two ignition coils and the secondary spark plug wires to the valve rocker arm cover.
^
Tighten the ignition coil bolts to 3 Nm (27 inch lbs.).
4. Install the two crankcase vent hoses to the valve rocker arm cover.
5. Install the accelerator cable to the accelerator cable bracket.
