Tracker 2WD L4-1.6L VIN 6 (2000)
Shifter M/T: Service and Repair
Gearshift Lever Case Disassemble
Removal Procedure
For gear shift lever case component. Refer to Gearshift Controls.
1. Remove 1 inner and outer roll pin (9) and the gearshift arm (8) from the gearshift shaft (14).
2. Remove the gearshift control lever bushing (7) from the gearshift arm (8).
3. Remove the 1 roll pin (9) from the gearshift shaft (14) releasing tension on the gearshift limit spring.
4. Remove the 1 inner and outer roll pin (9) from the gearshift lever (13).
5. Remove the 1 roll pin (9) from the reverse gearshift limit yoke (11).
6. Unstake the gearshift lever case plug (15).
7. Remove the gearshift lever case plug (1) from the gearshift lever case (2).
Important: The gearshift lever case contains an inner and outer select return spring on the left side only. The right side contains a single select return
