Tracker 4WD V6-2.5L VIN 4 (2001)
2. Install the crankshaft sprocket (2) to the crankshaft (1).
3. Verify that the Knock-pin (1) on the right intake camshaft is aligned with the match mark (2).
4. Install the right primary sprocket to the intake camshaft with the RH mark facing forward.
Notice: Refer to Fastener Notice in Service Precautions.
5. Secure the sprocket (1) with the bolt while holding the intake camshaft (2) with a wrench.
Tighten the bolt to 80 Nm (57.5 ft. lbs.).
