Tracker 4WD V6-2.5L VIN 4 (2001)
1. Tilt the top of the radiator towards the engine and install the condenser fan between the radiator and the front upper panel.
2. Tilt the top of the radiator towards the engine and install the condenser between the radiator and the front upper panel.
NOTE: Refer to Fastener Notice in Service Precautions.
3. Install the upper radiator mounting bolts.
Tighten
Tighten the radiator mounting bolts to 20 N.m (15 lb ft).
4. Secure the condenser with the lower 2 bolts and the upper 2 brackets.
Tighten
Tighten the condenser mounting bolts to 20 N.m (15 lb ft).
5. Install new O-rings lubricated with mineral base 525 viscosity refrigerant oil to the condenser fittings.
6. Connect the condenser outlet tube (6).
Tighten
Tighten the condenser outlet tube fitting to 35 N.m (26 lb ft).