Aspen 2WD V8-4.7L (2007)
3. Remove the inner second row seat cushion (2) to seat back (1) bracket trim cover.
4. Disconnect the inoperative heated second row seat back element electrical connector (3) and remove the harness routing clip.
5. Locate the wires leading from the inoperative heating element and cut them off flush with the edge of the original heating element.
Installation
INSTALLATION
SEAT CUSHION ELEMENT
CAUTION: During the installation of the replacement heating element, be careful not to fold or crease the element assembly. Folds or creases
will cause premature failure.
1. Peel off the adhesive backing on the back of the replacement heating element (2) and stick directly on top of the factory installed heating element
(1).
2. Connect the heated second row seat cushion element electrical connector (2) and install the harness routing clip to the rear center floor console
bracket (1).
3. Install the rear center floor console.
4. Connect the battery negative cable.
5. Verify heated rear seat system operation.
