Aspen 2WD V8-4.7L (2007)
6. Install the appropriate seat cushion cover.
NOTE: Make certain the seat wire harness is correctly routed through the seat and seat back. The excess wire between the cushion and back elements
should be securely tucked between the rear of the cushion foam and the rear carpet flap of the trim cover.
SEAT BACK ELEMENT
CAUTION: During the installation of the replacement heating element, be careful not to fold or crease the element assembly. Folds or creases
will cause premature failure.
NOTE: Second row heated seat cushion shown, second row heated seat back similar.
1. Peel off the adhesive backing on the back of the replacement heating element (2) and stick directly on top of the factory installed heating element
(1).
2. Connect the heated second row seat back element electrical connector (3) and install the harness routing clip.
3. Connect the battery negative cable.
4. Verify heated rear seat system operation.
5. Install the appropriate seat back trim cover (1).
NOTE: Make certain the seat wire harness is correctly routed through the seat and seat back. The excess wire between the cushion and back elements
should be securely tucked between the rear of the cushion foam and the rear carpet flap of the trim cover.
