Aspen 2WD V8-4.7L (2007)
7. Install two bolts into the pinion flange threaded holes, 180 degrees apart. Position Holder 6719A against the flange and install and tighten two
bolts and washers into the remaining holes.
8. Hold the flange with Holder 6719A and remove pinion nut and washer.
9. Mark a line across the pinion shaft and flange (1) for installation reference.
10. Remove companion flange (1) with Puller C-452 (2).
11. Remove pinion seal with seal puller.
Installation
INSTALLATION
1. Apply a light coating of gear lubricant on the lip of pinion seal.
2. Install new pinion seal with Installer C-4076-B (3) and Handle C-4735 (1).