Aspen 4WD V8-5.7L Hybrid (2009)
6. Raise and support the vehicle.
7. Route the cable through the underbody bracket (1) and seat the cable end fitting (2) in the bracket.
8. Connect the cable to the cable connector.
9. Perform the park brake adjustment procedure, See: Parking Brake Tensioner/Adjustments.
10. Lower the vehicle.
Rear Cable
REAR PARK BRAKE CABLE
NOTE: Pull on the cable to ensure it is locked into place.
1. Push each cable end through the brake cable support plate hole until the cable end fitting tabs lock into place.
2. Push the cable (4) through the frame bracket.
3. Lock the left cable end fitting tabs (3) into the frame bracket hole.
