Aspen 4WD V8-5.7L Hybrid (2009)
INSTALLATION
WARNING: On vehicles equipped with the high voltage system, you must thoroughly read and follow all High Voltage Safety procedures. In
addition, before performing any diagnostic or service procedure near a high voltage component, you must perform the High
Voltage Power Down. Failure to follow these instructions may result in possible serious or fatal injury See: Hybrid Drive
Systems/Battery System, Hybrid Drive/Service Precautions
1. Apply Mopar(R) Lock & Seal Adhesive to the intake manifold retaining bolts.
2. Install new intake manifold seals (1,3).
3. Position the intake manifold and connect the manifold air pressure (MAP) sensor (3) electrical connector (1).
