Aspen 4WD V8-5.7L Hybrid (2009)
5. Install the seal boot (2) onto the seal slinger (3)
6. Install a new seal boot clamp onto the seal boot, at the seal slinger, and tighten the clamp with Crimp Tool C-4975A
7. Install the front propeller shaft. See: Drive/Propeller Shafts, Bearings and Joints/Drive/Propeller Shaft/Service and Repair/Removal and
Replacement/Drive Shaft - Installation
8. Check the transfer case fluid level and correct as necessary. See: Service and Repair/Procedures/MP3010 Transfer Case - Fluid Drain and Refill