Crossfire V6-3.2L VIN L (2004)
Garage Door Opener Transmitter: Symptom Related Diagnostic Procedures
If the universal transmitter is inoperative, see the owner s manual in the vehicle glove box for instructions on training the universal transmitter. Retrain
the transmitter using a known good remote as instructed in the owner s manual and test the transmitter operation again. If the transmitter is still
inoperative, test the universal transmitter with a Radio Frequency Detector special tool.
1. Turn the Radio Frequency (RF) Detector ON . A chirp will sound and the green power LED will light. If the green LED does not light, replace
the battery.
2. Hold the RF detector within one inch of the TRAINED universal transmitter and press any one of the transmitter buttons.
3. The red signal detection LEDs will light and the tool will beep if a radio signal is detected. Repeat this test three times.
4. If a RF signal is not detected, replace the universal transmitter and reprogram as instructed in the owner s manual.
