Crossfire V6-3.2L VIN L (2004)
3.
Inspect the radiator inlet hose position (Figure 1):
>
If there is GREATER THAN 1/2" (12.5 mm) clearance between inlet hose and the two (2) bosses on the radiator shroud (Figure 2), no
further action is necessary. Install the air inlet to air cleaner housing tube and return the vehicle to the customer.
>
If there is LESS THAN 1/2"(12.5 mm) clearance between the inlet hose and the two (2) bosses on the radiator shroud and the hose
shows no evidence of contact with the bosses (Figure 2), the hose must be repositioned. Continue with Step 4.
>
If there is LESS THAN 1/2" (12.5 mm) clearance between the inlet hose and the radiator shroud bosses (Figure 2), and the hose has
visible evidence of hose wear from contact with the bosses, the hose must be replaced. Continue with Section B - Replace Radiator Inlet
Hose.
NOTE:
A hose with rub mark(s) only (no wear/notch in hose) does not require replacement.
