Pacifica V6-3.8L (2008)
Front Crankshaft Seal: Service and Repair
Removal
REMOVAL
1. Disconnect negative cable from battery.
2. Raise vehicle on hoist. Remove right wheel and inner splash shield.
3. Remove accessory drive belt. See: Drive Belts, Mounts, Brackets and Accessories/Drive Belt/Service and Repair/Removal and
Replacement/Accessory Drive Belt - Removal
4. Remove crankshaft damper. See: Cylinder Block Assembly/Harmonic Balancer - Crankshaft Pulley/Service and Repair/Vibration Damper -
Removal
5. Position Special Tool 6341A (2) on crankshaft nose. Carefully screw the tool into the seal until it engages firmly. Be careful not to damage that
crankshaft seal surface of cover
6. Remove oil seal by turning the forcing screw (2) until the seal disengages from the cover.