PT Cruiser L4-2.4L (2008)
Lateral Stabilizer Rod: Service and Repair
Installation
Bell Crank
BELL CRANK
CAUTION: Although both ends of the bell crank appear to be the same, they are not. When installing the watts links or bell crank, make sure
the bell crank is properly positioned. When mounted properly, the words "BACK UP" (1) should be able to be read from the rear over the top
of the axle. If the words cannot be read at this position, the bell crank must be removed and reinstalled so that the words "BACK UP" can be
read on the upper rear of the bell crank once installed.
1. Install the pivot bolt (7) through the front of the watts link bell crank (9). Make sure the words "BACK UP" are towards the rear (Refer to
preceding Caution).
2. Start the pivot bolt with the bell crank attached into the front of the axle (11) center mounting hole.
3. Position the words "BACK UP" on the bell crank so that they can be read from the rear over the top of the axle (Refer to preceding Caution).
