PT Cruiser L4-2.4L Turbo (2009)
13. Remove the two rear mounting screws (4) attaching the ICU mounting bracket (3) to the body (1).
14. Lower the vehicle.
15. Remove the front mounting screw (2) attaching the ICU mounting bracket (3) to the body (1).
16. Lift the ICU and mounting bracket from the vehicle.
17. To separate the ABM from the HCU, See: Overhaul/Integrated Control Unit (ICU) - Disassembly.
Integrated Control Unit (ICU) - Installation
INSTALLATION
1. Place the ICU and mounting bracket (3) into the engine compartment, inserting the bracket hooks into the hanger holes in the body frame rail (1).
2. Install the front mounting screw (2) attaching the ICU mounting bracket (3) to the body (1). Do not tighten screw at this time.
3. Raise and support the vehicle. See: Maintenance/Vehicle Lifting/Service and Repair
4. Install the two rear mounting screws (4) attaching the ICU mounting bracket (3) to the body (1). Tighten both screws to 23 Nm (200 in. lbs.).
5. Lower the vehicle.
6. Tighten the front mounting screw (2) to 23 Nm (200 in. lbs.).
