PT Cruiser L4-2.4L Turbo (2009)
Parking Brake Cable: Service and Repair
Installation
Rear Disc Brake Vehicles
REAR DISC BRAKE VEHICLES
NOTE: The following procedure applies to either of the two rear parking brake cables.
1. From underneath, push the parking brake cable through the hole in the floor pan of the vehicle making sure the cable sealing grommet is installed
in the floor pan as far as possible (without going all the way through) to ensure a good seal.
2. Guide the trailing end of the cable (1) through the hole in the axle trailing arm (2).
3. Align the cable routing brackets with their mounts on the trailing arm and insert the studs. Install the two fasteners (3) securing the cable and
routing brackets to the trailing arm (2). Tighten the mounting bolts to 14 Nm (125 in. lbs.).
4. Install the parking brake cable into the rear disc brake adapter. Be sure the locking fingers on the cable retainer are expanded once the cable is
pushed all the way into the brake adapter hole to ensure the cable is securely held in place.
5. Install the shoe actuator lever (1) on the parking brake cable (3).
