PT Cruiser L4-2.4L Turbo (2009)
Parking Brake Cable: Service and Repair
Removal
Rear Disc Brake Vehicles
REAR DISC BRAKE VEHICLES
WARNING: The automatic adjusting feature of this parking brake lever contains a clock spring loaded to approximately 19 pounds. Do not
release the automatic adjuster lockout device unless the rear parking brake cables and equalizer are connected to the lever output
cable. Keep hands out of automatic adjuster sector and pawl area. Failure to observe caution in handling this mechanism could
lead to serious injury.
WARNING: When repairs to the parking brake lever or cables are required, the automatic adjuster must be loaded and locked out to avoid
possible injury. The lever adjustment mechanism can be loaded and locked out as outlined in this procedure.
WARNING: The airbag system is a complex electromechanical unit. Before attempting to service any component near the occupant restraint
controller (ORC), first disconnect and isolate the battery negative cable. Allow the system capacitor to discharge for two (2)
minutes. Failure to do this could result in accidental airbag deployment and possible personal injury.
NOTE: Before proceeding, See: Service Precautions/Technician Safety Information See: Service Precautions/Vehicle Damage Warnings .
NOTE: The procedure below applies to either of the two rear parking brake cables.
1. If applicable to access battery negative terminal, unclip the air cleaner cover (two clips) and move the cover aside.
2. Disconnect and isolate the battery negative cable (1) from its post on the battery (4).
3. Block the tire and wheels so the vehicle does not move once the vehicle parking brake lever is released.
