PT Cruiser L4-2.4L Turbo (2009)
13. Install tire and wheel assembly (1) See: Maintenance/Wheels and Tires/Service and Repair/Removal and Replacement/Tires and Wheels -
Installation. Install and tighten wheel mounting nuts (3) to 135 Nm (100 ft. lbs.).
14. Lower the vehicle.
15. Ensure that the seal grommet on the cable that was installed from underneath is fully seated into the floor pan.
WARNING: The automatic adjusting feature of this parking brake lever contains a clockspring loaded to approximately 19 pounds. Do not
release the automatic adjuster lockout device unless the rear parking brake cables and equalizer are connected to the lever output
cable. Keep hands out of automatic adjuster sector and pawl area. Failure to observe caution in handling this mechanism could
lead to serious injury.
16. Route the parking brake cable under the carpeting, up to the parking brake cable retaining bracket on the floor pan. Insert the parking brake cable
through the retaining bracket. Push the cable in until the locking fingers on the cable retainer lock the cable into place.
17. Install the rear parking brake cables (3) into the equalizer (2) on the parking brake lever output cable (1).
18. Ensure that the parking brake cables are correctly installed on the equalizer and aligned with the cable track on the parking brake lever.
