Sebring V6-2.5L VIN N (1997)
4.
It the bracket DOES NOT have the raised pads, replace it with p/n MR311114.
5.
Remove and discard the upper and lower insulator bushings, and collar (Figure 1). Replace the discarded bushings with new upper p/n MR235627
and lower p/n MR235628 bushings, and collar p/n MB871748.
6.
Reassemble the rear strut assembly by compressing the coil spring and installing it onto the shock absorber. Make sure the lower edge of the coil
spring fits into the spring seat properly (Figure 3) and the upper bracket mounting studs are in line with the lower shock mounting boss hole
(Figure 4).
