Sebring Convertible V6-2.5L SOHC 24 Valve (1996)
way. **
**NOTE:
DO NOT REMOVE THE TRAILING LINK FROM THE BRACKET.**
4.
If the bolt heads are not flush to the sheet metal, remove the existing bolts one at a time. ** Enlarge the existing hole by drilling with a 90 degree
drill and a maximum 8.7 mm (11/32") drill bit and install the new bolt (P/N 06101671). Caution should be used to insure the bolt is installed flush
to the sheet metal.** Do not tap the hole first, the new bolts are self tapping. Torque bolts to 28 Nm (250 in. lbs.).
CAUTION:
THE NEW BOLTS MUST BE INSTALLED SO THAT THE BOLT HEAD IS FLUSH WITH THE SHEET METAL.
**5. Install the trailing link hanger bracket on the vehicle and loosely install the 4 attaching bolts. Then install 2 drift pins of appropriate size in the
positioning holes of the bracket (between each set of bolt holes) and into the locating holes in the body. **
**6. With the hanger bracket correctly positioned on the vehicle, torque the 4 hanger bracket mounting bolts to 34 Nm (25 ft. lbs.).**
7.
Repeat the procedure for the other side of vehicle.
POLICY: Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
Labor Operation No:
23-85-00-90
0.4 Hrs.
FAILURE CODE:
XX - Service Adjustment
