Sebring Convertible V6-2.5L SOHC 24 Valve (1996)
Convertible Top Pump: Service and Repair
Hydraulic Pump Assembly
REMOVAL
1. Disconnect battery negative cable.
2. Remove rear seat cushion and rear seat back.
3. Disconnect pump wire connector and ground connection.
4. Disconnect hydraulic lines from pump.
5. Remove motor pump assembly from vehicle. The rubber mounts are pressed and locked into the mounting bracket. Pull up on motor assembly to
remove.
INSTALLATION
1. Position hydraulic motor in vehicle.
2. Press hydraulic motor into mounts.
3. Connect hydraulic lines to pump.
4. Connect pump wire connector and ground connection.
5. Connect battery negative cable.
6. Fill and verify operation of hydraulic pump.
7. Install rear seat cushion and rear seat back.