Sebring Convertible V6-2.5L SOHC 24 Valve (1996)
5. Install a new O-ring on the end of the power steering pressure hose banjo fitting.
6. Install a new O-ring on the power steering pressure hose banjo fitting bolt.
7. Lubricate both O-rings using fresh clean power steering fluid.
NOTE: When installing the pressure hose it must be installed between the front bracket of the power steering pump and power steering pump
pulley.
8. Install the power steering pressure hose on the power steering pump pressure fitting and, loosely install the Banjo Bolt.
9. Install power steering pump drive belt on power steering pump pulley.
10. Install a 1/2 inch breaker bar in the square adjusting hole in the front power steering pump mounting bracket Then rotate pump to obtain the correct
drive belt tension. When correct drive belt tension is obtained first tighten the bottom 2 adjusting slot bolts at the power steering pump cast
