Sebring Convertible V6-2.5L VIN H (1997)
11. Raise the front suspension crossmember and steering gear back up into the vehicle.
12. Install the tie-strap holding the power steering fluid supply hose to the power steering pressure hose.
13. Lower vehicle.
14. Start the engine and let run for a few seconds, then turn the engine off.
15. Add fluid if necessary. Repeat the above procedure until the fluid level remains constant after running the engine.
16. Raise front wheels of vehicle off the ground.
17. Start the engine. Slowly turn the steering wheel right and left, lightly contacting the wheel stops. Then turn the engine off.
18. Add power steering fluid if necessary.
19. Lower the vehicle and turn the steering wheel slowly from lock to lock.
20. Stop the engine. Check the fluid level and refill as required.
21. If the fluid is extremely foamy, allow the vehicle to stand a few minutes and repeat the above procedure.
22. After hose is installed, check for leaks at all hose connections.
