Sebring Convertible V6-2.5L VIN H (1997)
pulley.
8. Install the power steering pressure hose on the power steering pump pressure fitting and, loosely install the Banjo Bolt.
9. Install power steering pump drive belt on power steering pump pulley.
10. Install a 1/2 inch breaker bar in the square adjusting hole in the front power steering pump mounting bracket Then rotate pump to obtain the correct
drive belt tension. When correct drive belt tension is obtained first tighten the bottom 2 adjusting slot bolts at the power steering pump cast
mounting bracket to a torque of 54 Nm (40 ft. lbs.). Then tighten the power steering pump mounting bracket top pivot bolt to a torque of 54 Nm
(40 ft. lbs.).
11. Position power steering pressure hose in outlet fitting of power steering pump, so hose is not contacting the pulley of power steering pump drive
belt. Then tighten the Banjo Bolt to a torque of 34 Nm (25 ft. lbs.).