Sebring Convertible V6-2.7L Flex Fuel (2008)
16.
Perform the following procedure to replace the tonneau extend micro switch:
a.
Remove and discard the extend micro switch mounting screws (Figure 9).
b.
Disconnect the extend micro switch grey connector from the body wiring harness.
c.
Remove and discard the extend micro switch.
d.
Install the new extend micro switch and tighten to 18 in. lbs. (2 N.m).
e.
Connect the extend micro switch grey connector to the gray body wiring harness connector.
17.
Connect the negative battery cable and close the hood.
18.
Perform the following procedure to retract the tonneau cover.
a.
Connect the StarSCAN to the data link connector located under the instrument panel knee blocker.
b.
Power up the StarSCAN and turn the key to the "ON" position.
c.
From the "HOME" screen select "ECU View".
d.
Scroll down the list and select "PTCM Power Top Control Module".
e.
Select "Misc. Functions".
f.
Select "Manual Top Movement" and then press the blue "Start" button.
g.
Read the manual top movement on-screen message and then press the "Next" button.
h.
Read the second manual top movement on-screen message and then press the "Next" button.
i.
Select the drop down box for the "1A Open Deck lid w/Top Open".
j.
Scroll down the drop down box list using the down arrow on the StarSCAN to "4A Tonneau Retract" and then press "Enter".
k.
Select "Next" and read the warning on the screen. Then select "Next" again.
l.
When the tonneau cover is fully retracted, select "Finish".
m.
Turn the ignition to the "OFF" position.
19.
Disconnect and remove the StarSCAN from the vehicle.
20.
Install the left side interior quarter trim panel (Figure 2).
21.
Install the left side interior quarter trim panel push pin.
22.
Tighten the left side cargo shield pivot bracket.
23.
Install the deck lid latch center trim panel (Figure 2).
24.
With the help of an assistant, move the deck lid assembly forward and down to engage the front deck lid latches.
CAUTION:
Be sure that both deck bar cylinders are in the "down" position before engaging the deck lid latches.
25.
Pull upward on the right and left deck bar cylinders to engage the deck lid latches.
26.
Tighten the hydraulic valve on the convertible top pump (turn clockwise) until the valve seats and is finger tight (Figure 3).
27.
Install the floor carpet panel back into the vehicle.
28.
Place the cargo shield in its extended position and then close the deck lid.
