Sebring LX Coupe V6-3.0L VIN H (2002)
1. Assemble two clutch discs and two clutch plates, one on top of the other, inside the reverse clutch retainer. Assemble both clutch plates so that the
places with no teeth (marked "A") are aligned with the holes in the retainer (marked "B").
2. Install the clutch reaction plate in the direction shown. Install it the same as the clutch plate, so that the places with no teeth (marked "A") are
aligned with the holes in the retainer (marked "B").
>> G <<
SNAP RING INSTALLATION
1. Install the snap ring into the groove of reverse clutch retainer.
2. Set special tools MB991790 <F4A42> or MB991789 <F4A51> and MD998924 as shown in the illustration, and compress the clutch element.
3. Check that the clearance between the snap ring and the clutch reaction plate is within the standard value. If not within the standard value, select a
snap ring so that it is.
Standard value:.........1.5 - 1.7 mm (0.0591. 0.0669 inch)
