chrysler Workshop Repair Guides

Chrysler Workshop Service and Repair Manuals

Body - Driver's Window Auto-Down Feature Inoperative|Page 8534 > < Body - Driver's Window Auto-Down Feature Inoperative|Page 8532
Page 3
background image

Procedure B

1.

If wind noise improvements were noted during diagnosis when the gap between the front door and body were taped off, vehicles built after May
15, 2001 the weatherstrip(s) should be replaced.

2.

For vehicles built on or before May 15, 2001, install clip, 05019585M, on the pinch flange in area where weatherstrip is loose. One lip in the
center of the pulled away area should be enough (Fig. 2).

3.

Install the weatherstrip over the clips and pinch flange.

NOTE

WEATHERSTRIPS CAN BE INSTALLED WITHOUT REMOVING TRIM PANELS.

4.

Repeat procedure on all loose primary weatherstrips as necessary.

Procedure C

1.

There should be a visible gap (not touching) between the front edge of the front window flag speakers and the front door body mounted

Body - Driver's Window Auto-Down Feature Inoperative|Page 8534 > < Body - Driver's Window Auto-Down Feature Inoperative|Page 8532