Sebring Sedan V6-3.5L (2009)
7. Install the return hose (1) at the return tube (2) and install the clamp. If a screw-clamp is used, tighten it to 2.5 Nm (20 in. lbs.).
8. Install the lower fascia valance.
9. If equipped, install the belly pan below the engine.
10. Lower the vehicle.
11. Install the coolant recovery bottle. See: Engine, Cooling and Exhaust/Cooling System/Coolant Reservoir/Service and Repair/Coolant Recovery
Bottle - Installation
12. Install the power steering fluid reservoir. See: Steering and Suspension/Steering/Power Steering/Power Steering Fluid Reservoir/Service and
Repair/Reservoir, Power Steering Pump - Installation
13. Fill and bleed the power steering system. See: Steering and Suspension/Steering/Service and Repair/Steering - Power Steering System Bleeding
14. Check for leaks.
Supply Hose
3.5L ENGINE
1. Slide hose clamps (1, 3) onto the ends of the power steering fluid supply hose (2) far enough to clear the fittings on the reservoir and pump once
the hose is installed.
2. Place the pump end of the supply hose onto the pump supply fitting (4). Expand the hose clamp (3) and slide it over the hose and pump supply
fitting. Secure the clamp once it is past the bead formed into the fluid supply fitting.
3. Lift the coolant recovery container as high as its connected hoses will allow, then install the clip (6) in the mounting hole (5) securing the supply
hose to the coolant recovery container's lower mounting point.
