Town & Country V6-3.3L Flex Fuel (2008)
8. Remove the screw (2) that secures the side impact sensor to the lower sliding door channel panel.
9. Disconnect the body wire harness connector (4) from the side impact sensor (3) on the top of the lower sliding door channel panel.
10. Pull the side impact sensor straight up from the mounting location to unsnap the anti-rotation pin on the base of the sensor from the clearance hole
in the lower sliding door channel panel.
11. Remove the side impact sensor from the vehicle.
12. Using door trim panel tool C-4829 or equivalent, remove the wire harness routing clips located under the drive assembly (3).
13. Pull the harness (4) out of the body channel and set aside.
14. Remove the sliding door drive tensioner bolt (1) and remove the tensioner from the sliding door lower hinge (2).
15. Remove the hold-open striker retaining bolts (4) and remove the hold open striker (1).
