Town & Country V6-3.8L (2009)
NOTE: The flat sides (3) on the upper can flange must be positioned toward the sides of the crossmember/vehicle within 15 degrees to
maintain proper NVH levels.
2. Verify proper alignment of the bushing (2) in the crossmember (1) as shown.
3. Install the bushings (4) from the top down until they bottom out using press C-4212F (2) and installer D-163 (2) or equivalent.
Front Suspension - Crossmember
CROSSMEMBER
1. Install the appropriate bushing. See: .
2. Place the crossmember centered on a transmission jack at working height. Secure the crossmember to the jack.
NOTE: Before stabilizer bar installation, inspect the cushions for excessive wear, cracks, damage and distortion. Replace any pieces failing
inspection.
NOTE: Before installing the stabilizer bar, make sure the bar is not upsidedown. The stabilizer bar must be installed so that when in mounted
position, the ends of the bar curve under the steering gear tie rods, up to the links.
