Town & Country SWB FWD V6-3.3L VIN G Flex Fuel (2000)
Intake Manifold: Service and Repair
Intake Manifold
REMOVAL
1. Remove windshield wiper module.
2. Perform fuel system pressure release procedure (before attempting any repairs). .
3. Drain the cooling system-only if lower intake manifold is to be removed. Refer to Cooling System for procedure.
4. Remove air inlet resonator to throttle body hose assembly.
5. Remove throttle cable. .
6. Remove wiring harness from throttle cable bracket.
Fig. 41
7. Remove automatic idle speed (AIS) motor and throttle position sensor (TPS) wiring connectors from throttle body (Fig. 41).
8. Remove EGR transducer connector.
9. Remove vacuum hose harness from throttle body (Fig. 41).
10. Remove PCV and brake booster hoses from air intake plenum.
Fig. 42