Leganza SE L4-2.2L DOHC D-TEC MFI (2001)
5. Disconnect the body harness from the ABS harness at connector C107. This is forward of the left front wheel arch, between the engine fuse block
and the wheel arch.
6. Pull the body harness end of C107 into the wheel arch area and remove the DK BLU-BRN pair of speed sensor wires appropriate for the harness
being replaced.
7. Open the body harness cover enough to free the speed sensor harness being replaced.
8. Lower the vehicle.
9. Expose the body harness inside the vehicle body and free the speed sensor harness being replaced.
10. Open the trunk, uncover the spare tire compartment, remove the tape from the feed through grommet, and free the speed sensor harness from the
body harness.
11. Raise and suitably support the vehicle.
12. Disconnect the speed sensor cable from the sensor harness cable being replaced.
13. Remove the tape sealing the wiring harness and the rear speed sensor harnesses to the grommet passing them through the floor of the vehicle.
14. Pull the harness being replaced through the grommet.
Installation Procedure
