Leganza SE L4-2.2L DOHC D-TEC MFI (2001)
8. Remove the upper condenser mount nuts.
9. Tilt the condenser to the rear away from the radiator mount support.
10. Lift the condenser up and out of the engine compartment.
11. Cap all the open lines and the fittings to prevent contamination.
Installation Procedure
1. Make sure the condenser rubber mounts are in place.
2. Install the condenser into the vehicle. The lower mount shock protectors must fit into the holes provided.
3. Move the condenser forward into the radiator support mount holes.
4. Install the upper condenser mount nuts and the washers.
Tighten
Tighten the upper condenser mount nuts to 4 N.m (35 lb-in).